Camping Tent Troubleshooting

1. The method of blowing and straightening the tent pole
Answer: plug one end of the bent rod, then fill the fine yarn from the other end to the inside, fill the back pier, and then plug the mouth, gently beat with a wooden hammer (stick) at the bend (V or U), and fill the sand into the pipe without section, repeat the above steps, until the knock is straight, and the force should be light. The wind resistance of the straightened rod has been reduced, so a slightly thicker pipe can be found to be sleeved here to increase the strength. If the rubber band is troublesome during operation, it can be removed and then carried out the above operation.　An aluminium or iron tube should be inserted at the most stressed part of the pole to increase the strength.　If it is FRP, use a hot hair dryer to blow it straight or go to Sanfu to change it, 5 yuan.

2. The method of filling sand in the tent, the purpose of adding sand to the tent is to prevent the aluminum tube from becoming deflated and producing dead bends, and the steel bar of the bicycle is also a way to increase the strength of the steel bar of the bicycle into the stressed aluminum tube.

3. Tent packing problem
For some people, tent packing is a trivial matter, but it involves the interaction between the equipment manufacturer and the user.　If you often watch some outdoor activities of the video, you pay careful attention to their tents are in the backpack, not as we are generally hung outside the backpack, if you are using foreign tents, you will find that they and the biggest difference between them and domestic tents is that the camp pillar and the tent cloth are packaged separately, folded tent cloth, its volume conforms to the diameter of the inner perimeter of the backpack, so that the tent cloth can be placed in the backpack, and the camp pillar is inserted on both sides of the backpack, this is a foreign designer, considering the concept of the user, the previous outer frame type of aluminum frame backpack, The camp tent packaging problem is not big, but today's mainstream inner frame type straight backpack, it is difficult to carry the tent packaging method of domestic design, it is not impossible to change, as long as you give up the original manufacturer design to the consumer frame, naturally you can also carry it very comfortably.
The practice is to discard the original tent jacket, and instead use a sleeping bag cover or a sleeping bag waterproof cover to install the inner and outer tent cloth, so that the tent will not appear outside the backpack, so that the long-distance longitudinal walk or walk in the intermediate mountain is relatively free of the problem of the tent length and width of the backpack, think about the backpacker will hang the tent vertically in the backpack, the appearance is like tying meat dumplings, lying horizontally in the backpack, and afraid of hitting the trunk of the tree or falling wood.